PWR-01 series offers 0-10V or 0-5V monitor outputs.
To set the monitor output voltage range, follow these steps:
1) Press the CONFIG key twice.
2) Select CF13 using the VOLTAGE knob.
3) Set it to either “Lo” (0-5V) or “Hi” (0-10V) using the CURRENT knob.
For the voltage monitor output, use the A GND (pins 5, 10 or 15) and VMON (pin 2) on the J1 connector. For the current monitor output, use the A GND (pins 5, 10 or 15) and IMON (pin 12) on the J1 connector.
Please note that the signal common is connected to the negative (-) output of PWR-01 series. To prevent accidents when monitoring multiple PWR-01 series units, avoid connecting their A GNDs together and ensure proper isolation.
For the details, read the user’s manual – chapter of External Control – External Monitoring.
