PBZ Series
よくあるご質問 閲覧ランキング
- 耐電圧(耐圧)試験って何ですか?
- 直流電源を接続する配電盤のブレーカ選定について教えてください。
- 検査票、試験成績書、校正証明書、トレーサビリティ証明書について教えてください。
- 電波法の高周波利用設備に該当する製品はありますか。
- VISAライブラリについて教えてください。
- ウォームアップ時間はどれくらいですか。
- 製品に電安法適用表示(PSEマーク)がありません。違法ではないですか。
- 耐電圧試験器を操作するために、必要な資格はありますか。
- PWR-01シリーズのPOWER スイッチをオンにしても動作しません。どうしたら良いでしょうか。
- 製品におけるPCB含有の有無について教えてください。
- マニュアル通りにコマンドを送っているのですが動作しません。どうしたらよいでしょうか。
- Is it possible to set PBZ series to maintain the current limit without turning off the output?
- Why is the repetition count of Wavy for PBZ in the execute window stuck at 10,001?
- Is it possible to limit the output voltage to not exceed a certain value during the CC mode in PBZ series?
- How do I synchronize PBZ series?
- What is the setting resolution in CC mode of PBZ series?
- Is PBZ series capable of 1 ms voltage step setting?
- I’m trying to connect Wavy for PBZ to PBZ series via the USB interface, but the serial number is not displayed on the interface dialog box of Wavy for PBZ. What should I do?
- Can Wavy for PBZ be used for PBZ series in parallel operation?
- Is it possible to operate five units of PBZ series in series?
- Under external voltage control through the J1 connector of PBZ series, what is the output voltage when 10 V is input?
- Is it possible to remove one unit of PBZ series from PBZ SR (Smart Rack) series or PBZ BP (Bipolar Pack) series?
- What do the model names of PBZ series mean?
- Is there any useful software for creating arbitrary waveforms for PBZ series?
- How do I check when I have sent a compound command to PBZ series?
- If the output is turned off via the external contact during sequence operation in PBZ series, how can the sequence be restarted?
- Can PBZ series be controlled by voltage from the GPIB interface while controlling via the J1 connector?
- Can two PBZ series units be connected via their COM terminals to function as a bipolar power supply, providing positive and negative voltage outputs?
- Can PBZ series output the square wave of 10 µs under the output voltage control via the EXT SIG IN terminal?
- Is the trigger in the sequence sheet of Wavy for PBZ
- Can PBZ series be controlled by connecting a function generator to the external control terminal?
- Is it possible to monitor the output voltage and current of PBZ series?
- Does the parallel operation of PBZ series apply only to the same model?
- What is the measurement/display unit of the DC+AC of PBZ series?
- What do the “setting” and “rtg” mean in the DC output accuracy specifications of PBZ series?
- How can I output an AC current from PBZ series using commands?






