PBZ Series
よくあるご質問 閲覧ランキング
- 耐電圧(耐圧)試験って何ですか?
- 直流電源を接続する配電盤のブレーカ選定について教えてください。
- 検査票、試験成績書、校正証明書、トレーサビリティ証明書について教えてください。
- 電波法の高周波利用設備に該当する製品はありますか。
- VISAライブラリについて教えてください。
- ウォームアップ時間はどれくらいですか。
- 製品に電安法適用表示(PSEマーク)がありません。違法ではないですか。
- 耐電圧試験器を操作するために、必要な資格はありますか。
- PWR-01シリーズのPOWER スイッチをオンにしても動作しません。どうしたら良いでしょうか。
- 製品におけるPCB含有の有無について教えてください。
- マニュアル通りにコマンドを送っているのですが動作しません。どうしたらよいでしょうか。
- Can PBZ series output an AC waveform or noise waveform?
- When does the trigger signal outputs during the sequence operation of PBZ series – at the beginning of the step or at the end of the step?
- How do I synchronize PBZ series using commands?
- What is the lineup of PBZ series?
- What is the setting resolution of PBZ series?
- What are the error codes in PBZ series?
- Is the chassis terminal of PBZ series at the same potential as the chassis?
- Why doesn’t PBZ series accept the command of CURR LIM UPP?
- What are the PC requirements for Wavy for PBZ?
- During parallel operation of PBZ series, should I connect the sensing cable to the master or slave unit?
- Is the FINE setting available for the DC setting in PBZ series?
- Can I check the EXT GAIN setting from the front panel of PBZ series?
- Can PBZ series create arbitrary waveforms based on measured data?
- Is it possible to control PBZ series by LabVIEW?
- How do I control the output on/off via the external contact in PBZ series?
- Can PBZ series output arbitrary waveforms during synchronization?
- Why doesn’t PBZ series output its rated AC voltage/current?
- Can PBZ series accept programs during sequence operation?
- What is an output status of PBZ series when the sequence operation is complete?
- Is PBZ series considered high-frequency equipment under the Japanese Radio Law?
- Why doesn’t PBZ series operate by inputting trigger signals via the TRIG IN contact?
- Does PBZ series output an AC waveform based on 0V-0A?
- Does PBZ series record measurement data?
- How do I set the AC signal on PBZ series via Wavy for PBZ?
- While the output is turned on, is there voltage present on the OUTPUT ON STATUS pin of the J1 connector of PBZ series?






