PAT-T Series
よくあるご質問 閲覧ランキング
- 耐電圧(耐圧)試験って何ですか?
- 直流電源を接続する配電盤のブレーカ選定について教えてください。
- 検査票、試験成績書、校正証明書、トレーサビリティ証明書について教えてください。
- 電波法の高周波利用設備に該当する製品はありますか。
- VISAライブラリについて教えてください。
- ウォームアップ時間はどれくらいですか。
- 製品に電安法適用表示(PSEマーク)がありません。違法ではないですか。
- 耐電圧試験器を操作するために、必要な資格はありますか。
- PWR-01シリーズのPOWER スイッチをオンにしても動作しません。どうしたら良いでしょうか。
- 製品におけるPCB含有の有無について教えてください。
- マニュアル通りにコマンドを送っているのですが動作しません。どうしたらよいでしょうか。
- Does PAT-T series operate a sequence function?
- Why is there a gap between the external voltage and the actual output voltage/current from PAT-T series?
- What is a detection method of controlling the output on/off through an external contact in PAT-T series?
- Can I use a Form B contact relay for the shutdown control of PAT-T series?No, please use a Form A contact relay instead. PAT-T series cannot change the control logic.
- What is the model of the crimper used for the J1 connector of PAT-T series?
- I am controlling PAT-T series via the J1 connector. Why is the RMT LED off on the front panel?
- Can I change the external control logic of the output on/off in PAT-T series?
- Is it available to use the Wavy during the PAT-T master-slave parallel operation?
- What is the conditions to operate the master-slave parallel operation in PAT-T series?
- How do I externally control the PAT-T master-slave parallel operation system through the J1 connector?
- How do I set up the PAT-T master-slave parallel operation system?
- Which RS232C cable do I use in PAT-T series?
- How do I check DC1 or DC3 during the flow control in RS232C communication in PAT-T series?
- What is the setting resolution of PAT-T series under the remote control through the communication interface?
- Is Windows XP supported by Wavy for PAT-T?
- During the flow control in RS232C communication in PAT-T series, can I set the output voltage/current or turn the output on/off?
- Do you have PLC programming examples for PAT-T series?
- Can I control PAT-T series via a PLC over the LAN interface?
- What happens if the remote sensing voltage exceeds 0.6 V to compensate in PAT-T series (on the one side of the output line) ?
- How do I cancel the PAT-T master-slave parallel operation to use each unit alone?
- How much is the contact rated current on the J1 connector of PAT-T series?
- How do I externally control PAT-T series via the J1 connector?
- The overvoltage protection (OVP) activates before the output voltage reaches the desired value. What should I do?
- Can PAT-T series flow the current more than the rated value if the output voltage is set to less than the rated value?
- How long is the response time speed under the external voltage control in PAT-T series?






